Forum Replies Created
-
Posts
-
Il s’agit bien d’une réparation de fortune , pas de quoi en effet à être très fier , je vais reprendre tout cela.
Il s’agit d’une carte qui fait le lien entre le bornier de connexion et la roue de sélection elle se situe sur le système de sélection. J’ai simplement suivi le fil du signal en partant du bornier.après avoir réalisé plusieurs essais, j’ai en effet solutionné une partie du pb , la sélection permet de lancer un morceau mais pas le bon si je me rapporte aux étiquettes issues du logiciel wallbox2mp3…
une idée ?
merci et bonne soirée
guillaume
C’était en effet un mauvais contact sur le signal. Le circuit imprimé est fatigué et la piste était HS.
j’ai pour l’instant fait une réparation de fortune , et le signal est désormais envoyé à la carte wallbox2mp3. Et la wallbox fonctionne !Hello to all!
great news I fix my problem it was a contact which was not good.
My wallbox is now working well !
many thanks to all of you for your help and support !have a nice evening
guillaume
I have done the test and both buttons are release as indicated in the adjustment section page 5
After that when I turn on the wallbox the wheel turn automatically to the initial position
but It still doesn’t work..
thanks for your message,
regarding the voltage I checked and I have a little bit more than 24vAC out of the transformer.
the contacts have been cleaned but maybe there are some contacts that I have forgotten. I will check again.
that is strange is about the selection wheel which turn And stop systematically at the same place . I thought that the wheel should stop according the selection…
Herewith a picture of the bridge :
As you can see there are 4 rows on the j101 the bridge is between the 2 nd and 3rd position on the 2nd row.i have seen in some forum that bridge position would permit to by pass the credit system.
Dear Scudie,
many thanks for your message, in fact the situation is the following : I have installed a wallbox2mp3 into my Wurlitzer 5220 , the cabling seems ok , and there is no error message (no flash red LED) everything seems ok also with the SDCard.
I have removed the cash system and put a bridge on the J101 as indicated in some forum , but I am not really sure that my bridge is fine ( 2nd row and between 2&3)..
when I make a selection, the wheel turn (only 1 full turn)) and stop exactly at the same place , and no music run ( no signal on the wallbox2mp3)
So my concern is about the wallbox and not necessary the wallbox2mp3 (for the moment..) and I would like know if my free play bridge is fine, and if there is other thing to check on the wallbox ( wheel system, cabling ,….)
many thanks for your help !
kind regards
Guillaume
